Operation Manual

UK • 5
Return to contents
Installing My-Speed
My-Speed comes with a windscreen suction cup bracket to mount the unit on to your vehicles windscreen.
When installing your My-Speed please consider the following:
The unit’s built-in GPS antenna has a clear view of the sky.
It is located in a position where you can easily view the LCD display without having to take your eyes too far from the road ahead 
and that you can reach the controls safely.
Does not interfere with the vehicles controls
Does not jeopardise the drivers or passengers safety.
You will be able to remove the device to perform downloads.
When adjusting the angle of the windscreen bracket please remove the My-Speed from the bracket FIRST before adjusting.
PLEASE NOTE: Be careful to choose a location that does not obscure the drivers view or where it might endanger the driver or
passengers should your vehicle suddenly come to a stop or be involved in an accident.
Installing My Speed using the windscreen Suction Cup bracket
Select a position within the windscreen so that the top of the unit has a clear view of the sky,
remembering that you need to connect the power connection cable as well as ensuring that
you can read the LCD display and reach the controls safely.
Clean the area where you wish to position the bracket thoroughly with a good quality 
glass cleaner
Adjust the angle of the bracket so that when the unit is attached to it you can view the 
display and operate the controls safely. Do not adjust the angle of the bracket when My-
Speed is attached.
Press the suction cup against the windscreen
Slide My-Speed onto the bracket.
To remove My-Speed from the windscreen bracket, simply slide the unit upwards off the 
plate.
Power the device using the power cable provided. Connect the USB plug on one end of 
the power cable into the socket marked USB on the back of My-Speed and plug the larger
plug into the cigarette lighter socket of your vehicle.
To turn on My-Speed press and hold the power button on the front of the device for 2
seconds.
Please note that no power cable other than the one provided with My Speed should be
used. My Speed operates on 5V DC and the power cable included is specifically designed
to provide this voltage. Using an alternative power cable could damage the unit and will
void the warranty.
Do not leave My-Speed plugged into the cigarette lighter socket when you start your
vehicle. The cigarette lighter socket is prone to power surges as the vehicle is started and
this may cause damage to your unit.
DO NOT leave the unit in view when the car is unattended during hot conditions. Exposing My-Speed
to extremely high temperatures can temporarily impair performance. Keep My-Speed out of sight
when not in use to help avoid potential theft.