Quick Start Guide

Locking

lever

Bracket

adjusters

4. Installing your Indago using the Windscreen Suction Cup bracket

You can mount your Indago to the inside of your vehicles windscreen using the suction cup windscreen

bracket provided. Simply select a position within the windscreen so that the top of the unit has a clear view

of the sky, remembering that you may need to connect the power connection cable as well as ensuring

that you can read the LCD display and reach the controls safely.

Follow these instructions to mount the unit in this way.

•

Clean the area where you wish to position the bracket

thoroughly with a good quality glass cleaner. This

allows a more secure seal on the windscreen.

•

Place the suction cup and bracket on the windscreen

and push the locking lever down to secure the bracket.

•

Adjust the angle of the bracket so that when the unit is

attached to it you can view the display and operate the

controls safely.

•

Position the Indago onto the bracket, by inserting the

bottom of the Indago first and finally clipping the top of

the bracket into the slot on the top of the unit as

indicated in the pictures ‘A & B’ on the right.

•

To remove the Indago, simply unclip the unit, by

pushing the top of the bracket marked push and

taking the unit from the holder.

•

The unit can be powered directly either from its internal

battery if it’s fully charged or powered from the cigarette

lighter socket. To use the cigarette lighter socket, plug

the smaller plug on one end of the power cable into the

socket marked DC 5V on the back of the Indago and

plug the larger plug into the cigarette lighter socket of

your vehicle.

Please Note: Only use the cigarette lighter power cable

provided with the Indago. Indago operates on 5V not

12V and using any other cigarette lighter power cable

will damage your device and void the warranty

Your Indago is now ready for use.