Quick Start Guide

QUICK START GUIDE

To utilise the Enigma Safety Camera database you will need to register your Indago

and perform a download.

Please refer to ‘Registering your Indago’ and ‘System Requirements and

Downloading’ in the User Manual on the CD Rom for further information.

Start Up

1. Installing the SD Card

Before using your Indago you will need to install the SD Card included with the device. The SD Card

comes complete with a digital map of the UK and Ireland and is also where the Enigma

camera

database is stored if you choose to download it.

Start by pushing the ‘Batt. ON/OFF’ switch located on the underside of the unit to the ‘ON’ position, then

remove the SD card from its packaging and insert it into the SD Card slot as indicated. Finally activate the

device by pressing and holding the standby power

button located on the left hand side of the unit for

2 seconds. As soon as the device is powered up

the Indago will automatically synchronise with

the SD Card. Once the synchronisation is

complete the SD Card will not function with

any other device. Your Indago is now ready to

navigate and the camera database can be

downloaded if necessary.

Please note that if the unit does not activate when

you press and hold the standby power button for

2 seconds it may require charging. Refer to the

section on ‘Power Connection and Charging’ in the

user manual located on the CD ROM.

Batt. ON/OFF

Switch

SD Card