Operation Manual

21
chosen your desired setting press the SELECT button. The unit will confirm
the new setting by displaying ‘Changed’ twice and will then return to the
Menu.
9. Speed Limit (Lmt)
This safety feature has been designed to let you program your Snooper
Evolution to alert you when you reach any speed you choose. For instance
you could set your unit to alert you when your speed reaches 30mph so that
you never accidentally stray over the speed limit.
To set the speed limit alert press either the MODE/MENU button or the
MUTE/CANCEL button you can increase or decrease the speed that you
would like to be alerted to. Once you have chosen your desired setting press
the SELECT button. The unit will confirm the new setting by displaying
‘Changed’ twice and will then return to the Menu.
10. Speed Unit
This feature allows you to choose which speed measurement method you
prefer either kilometres per hour (Km/h) or miles per hour (MPH). The device
is supplied with MPH turned on as the factory default setting.
To adjust the speed measurement type press either the MODE/MENU button
or the MUTE/CANCEL button to select your desired speed measurement
type. Once you have chosen your desired setting press the SELECT button.
The unit will confirm the new setting by displaying ‘Changed’ twice and will
return to the Menu.
11. Pre-Alert Setting
The pre-alert setting allows you to adjust the distance that your Snooper
Evolution will detect from when utilising GPS. You can set your pre-alert
distance in 100 metre increments from 100m to a maximum of 1000m or
alternatively you can select a new feature - ‘Auto Range’.
Auto-range simply selects the correct alert distance to each camera detected
depending on the speed limit of the road the camera is situated on. The
different alert distances are shown below.
Detection distances for Fixed Cameras and High Risk Zones
Speed Limit Pre-Alert
20mph 250m
30mph 300m
40mph 350m
50mph 400m
60mph 700m
70mph 700m
To adjust the pre-alert distance press either the MODE/MENU button or the
MUTE/CANCEL button to increase or decrease the distance or to select
Auto-range. Once you have selected your desired pre-alert setting press the
SELECT button. The unit will confirm the new setting by displaying ‘Changed’
twice and will then return to the Menu.
Features and Settings
Features and Settings
Return to contents