Operation Manual

17
Troubleshooting – Saving New Coordinates
When you attempt to save a new coordinate but the display reads ‘Weak Sgn’
it means that your Snooper Evolution is not receiving sufficient signal strength
to plot the position. Please ensure that the Snooper Evolution built-in GPS
antenna has a clear view of the sky, the unit is displaying the standby screen
and try again.
When you attempt to save the new coordinate and the display reads ‘Mem
Full’ it means that the memory in your Snooper Evolution is completely full. If
you want to store any new coordinates you will have to either delete some or
all of the existing coordinates stored in the unit’s memory.
9. Deleting Stored Coordinates
If you would like to delete any of the coordinates you have stored in your
units memory simply enter the units Menu by pressing the MODE/MENU
button (button 2) for approximately two seconds. When ‘Tone’ appears on the
display use either the MODE/MENU button (button 2) or the MUTE/CANCEL
button (button 1) to scroll through the Menu options until you see ‘MEM Edit’
and press the SELECT button (button 3).
Using buttons 1 or 2 you can select two further options of either ‘Sel clr’ or ‘All
clr’. If you want to delete all the coordinates at once select ‘All clr’ by pressing
button 3. The display will show ‘Del All?’ press button 3 again to confirm your
selection. Once all the coordinates have been cleared the display will read
‘All clrd’. If you would like to delete a specific coordinate then you will need to
select option ‘Sel clr’ and then using button 1 or 2 scroll through the list of
stored coordinates until the one you would like to delete is showing on the
display and press the SELECT button (button 3). The screen will read ‘Data
clr’ to confirm the coordinate has been deleted.
Operating Instructions
Operating Instructions
Return to contents