Operation Manual

15
If you would like to exit the Menu screen at any time press and hold button 2 for
approximately 2 seconds. If no buttons are pressed for a period of five seconds
the unit will automatically exit the Menu and return to your chosen standby
display.
3. Adjusting the Volume
The Snooper Evolution has an adjustable volume for controlling the loudness of
the audible alert. To increase the volume simply rotate the volume control on the
right hand side of the device, towards you. To decrease the volume of the unit
rotate the volume control away from you.
4. MODE/MENU Button
This button has two functions. The Mode function is used to select between three
types of settings, City, Motorway or All. When the button is pressed and held for
two seconds it allows you access to the Menu for further configuration of your
unit.
When selecting your preferred Mode you need to press the ‘SELECT’ button to
confirm the change.
CITY Mode
In CITY mode the Snooper Evolution will ignore any fixed safety cameras that
are located on a motorway and are in range of your unit but not an immediate
threat to you, as you are not actually travelling on that section of road.
MOTORWAY Mode
In Motorway mode (displayed as Mway) the Snooper Evolution will ignore any
fixed safety cameras that are not actually on a motorway road and are within
range of your unit but not an immediate threat to you as you are not actually
travelling on that section of road. If your speed drops below 20mph the device
will sound an audible alert and the message ‘Road Ch?’ will be shown on the
display to remind you that you may no longer be travelling on a section of
motorway and may need to change the mode to ‘CITY’ or ‘ALL’.
ALL Mode
In ALL Mode the Snooper Evolution will detect all fixed safety cameras that are
within the selected range of the unit. If you were travelling on a section of
motorway for instance it would mean that the unit could detect locations situated
on an ‘A’ road that are near to the motorway. As it is not on the road you are
travelling however it is not a threat and you might prefer to select the ‘Mway’
setting so that the unit would ignore unnecessary alerts.
PLEASE NOTE: Whilst in CITY mode the device will not detect any locations
located on a motorway. When the unit is in MWAY mode the unit will not detect
any locations located on ‘A’ roads so you need to remember to change modes
when leaving an ‘M’ type road.
5. Cancel Button
If during an alert you decide that you would like to cancel it simply press and hold
the MUTE/CANCEL button (Button 1). The display will automatically return to the
Standby screen and the device will be ready to alert you to the next GPS
coordinate.
Operating Instructions
Operating Instructions
Return to contents