Operation Manual

Caution: If you must use pliers to loosen the ring, be careful not to crush the

tip. Never use pliers or other tools to retighten the ring on the cigarette lighter

plug.

2. Pull the ring straight out, then remove the metal tip, spring and old fuse.

3. Check the fuse to see if it has blown. If it has, replace it.

4. Replace the metal tip and spring inside the ring, then place the fuse inside

the cigarette lighter plug and screw the ring back onto the plug. Make sure

the metal tip is visible when you reassemble the cigarette lighter plug.

Direct connecting/hard wiring your Evolution

You can power your Snooper Evolution by wiring it directly to your vehicles

12V electrical system using the ‘Hard Wire’ cable supplied as standard with

your unit. First connect the positive side of the cable (marked with a red plus

symbol) to a 12V switched live. This is a live that is ON when the ignition is

ON and OFF when the ignition is OFF. The negative side of the lead should

be connected to a negative ground, so it can be attached to any metal portion

of the vehicles frame. Next plug the small adaptor on the other end of the

lead into the DC 12V input socket on the back of the unit.

Important: If you are unfamiliar with this procedure, please consult a

professional auto electrician.

Installing the Evolution

Return to contents