Operation Manual

Power Connection

Using the cigarette lighter socket

The Evolution comes with a power cable designed to plug into your vehicles

cigarette lighter socket. Take the lead and plug the smaller end into the DC

12V input socket on the back of the Evolution and plug the cigarette lighter

adaptor into your vehicles cigarette lighter socket.

Please Note: Do not leave your Evolution plugged into the cigarette lighter

socket when you start your vehicle. The cigarette lighter socket is prone to

power surges as the vehicle is started and this may cause damage to your

unit.

If the device does not power up please check that the cigarette lighter socket

is clean of any debris, remembering not to insert metal objects into the

socket. Check that the cigarette lighter adaptor is inserted all the way into the

socket and check that the fuse in the cigarette lighter adaptor is operational. If

your Evolution will still not power up, please check that the cigarette lighter in

your vehicle is functioning correctly.

Replacing the Fuse

If the Evolution stops operating, the fuse in the cigarette lighter plug may

have blown. If it has blown, follow these steps and replace it with a 2 amp, 5 x

20mm fast acting fuse.

Caution: Using a fuse that does not meet these ratings or defeating fuse

protection can damage your unit, the power cable, or the vehicles electrical

system.

1. Grasp the ring near the tip of the cigarette lighter plug, and then carefully

unscrew the ring by turning it counter clockwise.

Installing the Evolution

Return to contents