Operation Manual

RS232
RD
11
Installing your Snooper Evolution using the Windscreen Suction
Cup bracket
You can mount your Evolution to the inside of your vehicles windscreen using
the suction cup windscreen bracket provided. Simply select a position within
the windscreen so that the top of the unit has a clear view of the sky,
remembering that you need to connect the power connection cable as well as
ensuring that you can read the LED text display and reach the controls
safely.
Follow these instructions to mount the unit in this way.
•
Install the suction cups onto the bracket by fitting them into the holes as per
the diagram below.
•
Clean the area where you wish to position the bracket thoroughly with a
good quality glass cleaner
•
Carefully bend the bracket so that when it is mounted onto the windscreen
with the Evolution attached, the Control Panel is facing in the desired
direction so that you can easily see the LED display and safely operate the
controls.
•
Slide the Evolution onto the bracket until it is secure.
•
To remove the Evolution, simply slide the unit off the bracket from the front.
•
Finally plug the smaller plug on one end of the power cable into the socket
marked DC12V on the back of the Evolution and plug the larger plug into
the cigarette lighter socket of your vehicle. Your Snooper Evolution is now
ready for use. For further information please read the section on Power
Connection on page 12.
Installing the Evolution
Installing the Evolution
Return to contents