Operation Manual

10
Installing your Snooper Evolution using the Hook and Loop
fastener
Your Evolution can be installed easily with the hook and loop fastener if you
have a sufficiently flat area on your dashboard. Please remember that you
need to connect the power connection cable as well as ensuring that you can
read the LED text display and reach the controls safely.
Follow these instructions to mount the device in this way.
•
Use a damp cloth to thoroughly clean the bottom of the Evolution and the
area where you intend to mount your unit.
•
With the two parts of the Hook and Loop fastener still fastened together,
peel the backing tape from the softer ‘Loop’ side of the fastener and apply
it to the bottom of the unit.
•
Next remove the backing tape from the ‘Hook’ side of the fastener, again
whilst the two parts are still fastened and position the unit onto the desired
area. If possible leave the Hook and Loop fastener for 24 hours to adhere
properly before using regularly.
•
Finally plug the smaller plug on one end of the power cable into the socket
marked DC 12V on the back of the Evolution and plug the larger plug into
the cigarette lighter socket of your vehicle. Your Snooper Evolution is now
ready for use. For further information please read the section on Power
Connection on page 12.
Installing the Evolution
Installing the Evolution
Return to contents