Operation Manual

10. Speed Unit

This feature allows you to choose which speed measurement method you

prefer either miles per hour (mph) or kilometres per hour (kmh). The

device is supplied with mph turned on as the factory default setting.

To adjust the speed measurement type press either the MODE/MENU

button (button 2) or the MUTE/CANCEL button (button1) to select your

desired speed measurement type. Once you have chosen your desired

setting press the SELECT button (button 3). The unit will confirm the new

setting by displaying 'Changed' twice and will return to the Menu.

11. Pre-Alert Setting

The pre-alert setting allows you to adjust the distance that your Snooper

Evolution will detect from when utilising GPS. You can set your pre-alert

distance in 100 metre increments from 100m to a maximum of 1000m or

alternatively you can select a new feature - ‘Auto Range’.

Auto-range simply selects the correct alert distance to each camera

detected depending on the speed limit of the road the camera is situated

on. The different alert distances are shown below.

Detection - Fixed Cameras Detection - High Risk Zones

Speed Limit Pre-Alert Speed Limit Pre-Alert

20 or 30mph 200m 20 or 30mph 300m

40mph 250m 40 or 50mph 500m

50mph 300m 60 or 70mph 700m

60mph 400m

70mph 500m

To adjust the pre-alert distance press either the MODE/MENU button

(button 2) or the MUTE/CANCEL button (button 1) to increase or

decrease the distance or to select Auto-range. Once you have selected

your desired pre-alert setting press the SELECT button (button 3). The

unit will confirm the new setting by displaying ‘Changed’ twice and will

then return to the Menu.

12. Radar/Laser Settings

This setting allows you to turn the Laser receptor built into the unit ‘On’ or

‘Off’. It also allows you to configure the unit to alert you to Radar sources

as well as Laser sources if you have purchased the S100 RLD as an

optional extra.

Please be aware that you will need to switch Laser detection OFF if

you intend to visit European countries where the use of Laser

detection is prohibited such as France. Please note that you should

always check local laws before using the Laser receptor in any

country outside the UK.

There are three options available as follows: -

i) RD & Laser Detection of both radar and laser sources (S100 RLD

only)

Return to Contents Page