Operation Manual

The following menu options are available on your unit. Press

SELECT once your desired option is displayed.

1. Tone

There are three audible settings to choose from, a Hard Tone, a Soft

Tone or Silent (Off). To select your desired setting press either the

MODE/MENU or MUTE/CANCEL buttons and scroll through the options

available. Once you have chosen your preferred setting press the

SELECT button. The unit will confirm the new setting by displaying

'Changed' twice and will then return to the Menu.

2. Warning Selection

The Snooper Evolution allows you the option of choosing whether or not

you would like to receive advanced warnings of Primary Schools

(Schools are time sensitive on the Evolution - 08:30-09:30am,

12:00-13:00 and 15:30 to 16:30) and areas such as Accident Black spots

that may not currently have Speed Trap's installed near them but which

are still considered High Risk Zones. Schools and High Risk Zones can

be selected independently by following these instructions.

To adjust these settings use either the MODE/MENU button (button 2) or

the MUTE/CANCEL button (button1) to go through the options (School,

Risk zone or Others). Once your desired option is displayed press the

SELECT button (button 3). Then using either buttons 1 or 2 you can

select your preferred setting. Once you have chosen your desired setting

press the SELECT button. The unit will confirm the new setting by

displaying 'Changed' twice and will then return to the Menu.

3. Brightness

There are three settings that you can choose from for the brightness of

the LED display. They are Bright, Dark or Dim.

To adjust the brightness press either the MODE/MENU button (button 2)

or the MUTE/CANCEL button (button1) until your preferred setting is

displayed then press the SELECT button (button 3). The unit will confirm

the new setting by displaying 'Changed' twice and will return to the Menu.

4. Set Time

The Snooper Evolution can be configured to display the time on the

Standby Screen. This reading is updated by the GPS Atomic Clock and is

generated directly from Greenwich Mean Time (GMT) and is completely

accurate. However it does not automatically adjust for British Summer

Time (BST) and is required to be adjusted manually. The device is

supplied with the factory default setting of GMT.

To adjust the clock to British Summer Time press the MODE/MENU

button until ‘GMT + 1’ is displayed then press the SELECT button. The

unit will confirm the new setting by displaying ‘Changed’ twice and will

then return to the Menu.

To adjust the clock to Greenwich Mean Time press the MUTE/CANCEL

button until ‘GMT + 0’ is displayed then press the SELECT button. The

unit will confirm the new setting by displaying ‘Changed’ twice and will

then return to the Menu.

Return to Contents Page