Operation Manual

3. Adjusting the Volume

The Snooper Evolution has an adjustable volume for controlling the

loudness of the audible alert. To increase the volume simply rotate the

volume control on the right hand side of the device, towards you. To

decrease the volume of the unit rotate the volume control away from you

4. MODE/MENU Button

This button has two functions. The Mode function is used to select

between three types of settings, City, Motorway or All. When the button

is pressed and held for two seconds it allows you access to the Menu for

further configuration of your unit.

CITY Mode

In CITY mode the Snooper Evolution will ignore any alert generated

through GPS that is actually located on a motorway and is in range of

your device but not an immediate threat to you, as you are not actually

travelling on that section of road. Laser alerts remain unaffected when

selecting this mode.

MOTORWAY Mode

In Motorway mode (displayed as Mway) the Snooper Evolution will ignore

any alert generated through GPS that is not actually on a motorway road

and is within range of your device but not an immediate threat to you as

you are not actually travelling on that section of road. If your speed drops

below 20mph the device will sound an audible alert and the message

'Road Ch?' will be shown on the display to remind you that you may no

longer be travelling on a section of motorway and may need to change

the mode to 'CITY' or 'ALL'. Laser alerts remain unaffected when

selecting this mode.

ALL Mode

In ALL mode the Snooper Evolution will detect all alerts generated

through GPS that are within the selected range of the unit. If you were

travelling on a section of motorway for instance it would mean that the

unit could detect locations situated on an 'A' road that is near to the

motorway. As it is not on the road you are travelling however it is not a

threat and you might prefer to select the 'Mway' setting so that the unit

would ignore unwanted signals located by GPS. Laser alerts remain

unaffected when selecting this mode.

PLEASE NOTE: Whilst in CITY mode the device will not detect any

locations located on a motorway. When the unit is in MWAY mode the

unit will not detect any locations located on 'A' roads so you need to

remember to switch modes when leaving an 'M' type road.

5. Cancel Button

If during an alert you decide that you would like to cancel it simply press

and hold the MUTE/CANCEL button (Button 1). The display will

automatically return to the Standby screen and the device will be ready to

alert you to the next GPS coordinate or laser source.

Return to Contents Page