Operation Manual

Operating Instructions

1. Starting Up

After you have successfully installed your Evolution and performed the

download it is time to perform the first start up. First make sure your vehicle is

parked in as open a space as possible, clear of tall trees and buildings so

that the built in GPS antenna has a clear view of the sky above. Next power

the unit up by turning the ON/OFF Volume dial towards you. The LED text

display will briefly read ‘Snooper’, Logic # (see page 23), Mway, City or All

(page 15) and finally ’Searching for Sat...’ will scroll across the screen as the

unit begins to search for satellite connection. The Evolution needs to acquire

a minimum of three satellites in order to work. Once this has been achieved

the Evolution will proceed to the Standby screen of your choice (See Standby

Screen later in this section. As soon as the standby screen is displayed your

Evolution is ready to use and will now automatically alert you of any locations

stored in it's database as well as laser alerts. A variety of audible and visual

alert patterns are explained later on in this section. See 'Features and

Settings' to personalise your unit.

As the GPS engine and antenna have never been used before, the first

'Cold' start could take anywhere from 15 - 50 minutes to establish a

satellite connection. Once initialised, subsequent start ups will take

less time and eventually should take only a matter of minutes.

2. Standby Screen

The are three selectable standby screens to choose from as shown below:

•

Atomic clock and compass

•

GPS signal strength and compass

•

Vehicle speed

To select your preference:

1 Press and hold the MODE/MENU button (for approximately two seconds)

until the unit displays ‘Tone’.

2 Using either buttons 1 or 2 scroll through the Menu items until the screen

reads ‘Scr Mode’ and press the SELECT button.

3 Using either buttons 1 or 2 scroll up or down through the options. When

you reach your desired setting, press the SELECT button again.

If you would like to exit the Menu screen at any time press and hold button 2

for approximately 2 seconds. If no buttons are pressed for a period of five

seconds the unit will automatically exit the Menu and return to your chosen

standby display.

MODE/MENU

MUTE

/CANCEL

NEW LOCATION

SELECT

Return to Contents Page