Operation Manual

Caution: If you must use pliers to loosen the ring, be careful not to crush

the tip. Never use pliers or other tools to retighten the ring on the

cigarette lighter plug.

2. Pull the ring straight out, then remove the metal tip, spring and old

fuse.

3. Check the fuse to see if it has blown. If it has, replace it.

4. Replace the metal tip and spring inside the ring, then place the fuse

inside the cigarette lighter plug and screw the ring back onto the

plug. Make sure the metal tip is visible when you reassemble the

cigarette lighter plug.

Direct connecting/hard wiring your Snooper Evolution.

You can power your Snooper Evolution by wiring it directly to your

vehicles 12v electrical system using the 'Hard Wire' cable supplied as

standard with your unit. First connect the positive side of the cable

(marked with a red plus symbol) to a 12v switched live. This is a live that

is On when the ignition is On and Off when the ignition is Off. The

negative side of the lead should be connected to a negative ground, so

can be attached to any metal portion of the vehicles frame. Next plug the

small adaptor on the other end of the lead into the DC 12V input socket

on the back of the unit.

Important: If you are unfamiliar with this procedure, please consult a

professional auto electrician

Return to Contents Page