Operation Manual

Power Connection

Using the cigarette lighter socket

The Evolution comes with a power cable designed to plug into your

vehicles cigarette lighter socket. Take the lead and plug the smaller end

into the DC 12v input socket on the back of the Evolution and plug the

cigarette lighter adaptor into your vehicles cigarette lighter socket.

Please Note: Do not leave your Evolution plugged into the cigarette

lighter socket when you start your vehicle. The cigarette lighter socket is

prone to power surges as the vehicle is started and this may cause

damage to your unit.

If the device does not power up please check that the cigarette lighter

socket is clean of any debris, remembering not to insert any metal objects

into the socket, check that the cigarette lighter adaptor is inserted all the

way into the socket and to check that the fuse in the cigarette lighter

adaptor is operational. If your Evolution will still not power up, please

check that the cigarette lighter in your vehicle is functioning correctly.

Replacing the Fuse

If the Evolution stops operating, the fuse in the cigarette lighter plug may

have blown. If it has blown, follow these steps to replace it with a 2 amp,

5 x 20mm, fast acting fuse.

Caution: Using a fuse that does not meet these ratings or defeating fuse

protection can damage your unit, the power cable, or the vehicles

electrical system.

1. Grasp the ring near the tip of the cigarette lighter plug, then carefully

unscrew the ring by turning it counterclockwise.

Return to Contents Page