Operation Manual

Installing your Snooper Evolution using the Windscreen Suction

Cup bracket

You can mount your Evolution to the inside of your vehicles windscreen

using the suction cup windscreen bracket provided. Simply select a

position within the windscreen so that the top of the unit has a clear view

of the sky, remembering that you need to connect the power connection

cable as well as ensuring that you can read the LED text display and

reach the controls safely

- Install the suction cups onto the bracket by fitting them into it's holes.

- Clean the area where you wish to position the bracket thoroughly with

a good quality glass cleaner.

- Carefully bend the bracket so that when it is mounted on to the

windscreen with the Evolution attached, the Control Panel is facing in

the desired direction so that you can easily see the LED display and

safely operate the controls.

- Slide the Evolution onto the bracket until it is secure.

- To remove the Evolution simply slide the unit off the bracket from the

front.

- Finally plug the smaller plug on one end of the power cable into the

socket marked DC12V on the back of the Evolution and plug the larger

plug into the cigarette lighter socket of your vehicle. Your Snooper

Evolution is now ready for use. For further information please read the

section on Power Connection on page 12.

RS232

Return to Contents Page