Operation Manual

10
Installing your Snooper Evolution using the Hook and Loop fastener
Your Evolution can be installed easily with the hook and loop fastener if
you have a sufficiently flat area on your dashboard. Please remember
that you need to connect the power connection cable as well as ensuring
that you can read the LED text display and reach the controls safely.
Follow these instructions to mount the control panel in this way.
- Use a damp cloth to thoroughly clean the bottom of the Evolution and
the area where you intend to mount your unit.
- With the two parts of the Hook and Loop fastener still fastened together,
peel the backing tape from the softer 'Loop' side of the fastener and
apply it to the bottom of the unit.
- Next remove the backing tape from the 'Hook' side of the fastener,
again whilst the two parts are still fastened and position the unit onto
the desired area. If possible leave the Hook and Loop fastener for 24hrs
to adhere properly before using regularly.
- Finally plug the smaller plug on one end of the power cable into the
socket marked DC12V on the back of the Evolution and plug the larger
plug into the cigarette lighter socket of your vehicle. Your Snooper
Evolution is now ready for use. For further information please read the
section on Power Connection on page 12
Return to Contents Page