Operation Manual

23
10. Logic
There are a number of different ways that you can programme your Snooper
Evolution to locate fixed cameras. You can choose between three different
Logic Modes:
Logic 1
When this mode is selected your unit will alert you via your chosen audible
alert as well as visual alerts of fixed cameras on both sides of the road.
Logic 2 (Factory Default Setting)
When this mode is selected your unit will alert you via your chosen audible
alert as well as visual alerts of fixed cameras on your side of the carriageway
only. The unit will not indicate the presence of cameras or monitoring vehicles
on the opposite side of the carriageway as you approach them.
Logic 3
When this mode is selected your unit will alert you with a hard tone audible
alert as well as visual alerts of fixed cameras on your side of the carriageway
but will only give you a soft tone audible alert and a visual alert of cameras on
the opposite side of the carriageway as you approach them. If you have voice
alerts selected you will get a voice alert as well as visual alerts of fixed
cameras on your side of the road and just a soft audible and visual alert of
cameras on the other side of the carriageway.
Selecting Your Preferred Logic Mode
To change the logic mode press either the MODE/MENU button (button 1) or
the MUTE/CANCEL button (button2) to select your preferred logic mode.
Once you have chosen your desired setting press the SELECT button
(button3). The unit will confirm the new setting by displaying ‘Changed’ twice
and will then return to the Menu.
11. Speed Limit (Lmt)
This safety feature has been designed to let you programme your Snooper
Evolution to alert you when you reach any speed you choose. For instance
you could set your unit to alert you when your speed reaches 30mph so that
you never accidentally stray over the speed limit.
To set the speed limit alert, press either the MODE/MENU button (button 1) or
the MUTE/CANCEL button (button2) until ‘ON’ is displayed. Then using
buttons 1 or 2 you can increase or decrease the speed that you would like to
be alerted to. Once you have chosen your desired setting press the SELECT
button (button3). The unit will confirm the new setting by displaying ‘Changed’
twice and will then return to the Menu.
To turn the Speed Limit feature OFF press either the MODE/MENU button
(button 1) or the MUTE/CANCEL button (button 2) until OFF is displayed then
press the SELECT button (button 3). The unit will confirm the new setting by
displaying ‘Changed’ twice and will then return to the Menu.
Features and Settings
Features and Settings
Return to contents