Operation Manual

Power Connection

Using the cigarette lighter socket

The Evolution is supplied with two power cables one of which can be

connected to the vehicles cigarette lighter socket as follows.

•

Connect the smaller right angled plug to the socket marked ‘DC 12V’ on the

Evolution.

•

Push the cigarette lighter plug firmly into the vehicles cigarette lighter

socket.

Please Note: Do not leave your Evolution plugged into the cigarette lighter

socket when you start your vehicle. The cigarette lighter socket is prone to

power surges as the vehicle is started and this may cause damage to your

unit.

If the device does not power up please check that the cigarette lighter socket

is clean of any debris, remembering not to insert metal objects into the

socket. Check that the cigarette lighter adaptor is inserted all the way into the

socket and to check that the fuse in the cigarette lighter adaptor is

operational. If your Evolution will still not power up, please check that the

cigarette lighter in your vehicle is functioning correctly.

Replacing the Fuse

If the unit stops operating first check the fuse in the cigarette lighter plug. If

the fuse has blown, follow these steps and replace it with a 2 amp,

6 x 30mm fast blow fuse.

Caution: Using a fuse that does not meet these ratings or removing fuse

protection can damage your unit, the power cable, or the vehicles electrical

system

1. Grasp the ring near the tip of the cigarette lighter plug, and then carefully

unscrew the ring by turning it counter clockwise.

Installing the Evolution

Return to contents