Operation Manual

Note:
Switching to the ‘auto scan’ mode does not change the current FM
transmitting frequency, as it remains the same as before the switch.
While in the ‘auto scan’ mode, the DAB2000 will automatically search for
three unused FM frequencies and save them into the memory in sequence
(from frequency 1 to frequency 3). When you are using the DAB2000 to listen
to a DAB service and you experience constant interference from another
source, this means that you are driving into an area where the present FM
frequency is used by an FM broadcaster. When this happens, you will need to
find an unused FM frequency for transmitting the DAB service to your car
radio. The enabled ‘auto scan’ feature can help you to do such a change
quickly by doing the following steps:
Operating on DAB2000
1. Press the FM button and the screen will show the current FM transmitting
frequency.
2. Keep pressing the FM button and it will go through the options from
frequency 1 to frequency 3, and the display will show 《 SX Frequency 》
where X ranges from 1 to 3 and Frequency is the auto scanned frequency.
Select the frequency you prefer and this will be the new FM frequency for
transmitting.
3. Press the Rotary Knob to confirm your selection. Alternatively, after 10
seconds, the FM transmitter will set and transmit the FM signal at the new
frequency. You can now listen to DAB stations via this new FM frequency.
Operating on vehicle radio
1. Manually change your vehicle radio’s FM frequency to match the new
DAB2000 transmitting frequency.
Note:
Alternatively, you can choose to recall an FM preset to change
frequency if the preset frequency i s unused and available. Please
refer to section on To recall FM transmitting frequency saved in
memory.