Operation Manual

1. Press the FM button, the screen will show the current FM Transmitting
Frequency《 Frequency 》.
2. Turning the Rotary Knob [◄] [►] quickly will allow you to st ep up or
down the FM frequency by 2MHz, or just turn the Rotary Knob [◄] [►]
to step up or down the FM frequency by 100KHz, until your desired FM
frequency is displayed (e.g. 106.7MHz). Make a note of the frequency you
have chosen.
3. Press the Rotary Knob to confirm your selection. Alternatively, after 10
seconds, the DAB2000 will set and transmit on the new FM frequency and
the screen will show 《 TO Frequency 》.
4. Press the FM preset of your vehicle radio corresponding to the same
frequency from step 2 above, if you have previously saved an FM
frequency for DAB reception. Otherwise, tune the vehicle radio to the
same FM frequency you selected on the DAB2000.
5. You can now listen to DAB stations via this new FM Frequency.
Note:
It is recommended to set the selected FM frequency you wish to use
as one of the memory presets of your vehicle’s radio. Selecting this
particular preset FM frequency, together with setting the DAB2000’s
FM transmitting frequency, will enable you to start listening to DAB
stations quickly.
While setting a new transmitting frequency is in operation and 《 TO
Frequency 》 is displayed, with the exception of the power button,
any button pressed is ignored by the DAB2000.
To save a desired FM transmitting frequency in memory
As unused FM frequencies may vary from one area to another, it is
recommended to save a few FM frequencies (up to a maximum of 4
frequencies) in the DAB2000 so that you can switch to a new FM transmitting
frequency instantly when you drive into an area where the original FM
frequency for DAB is no longer available.
1. Press the FM button, the screen will show the current FM transmitting
frequency 《 Frequency 》.
2. Turn the Rotary Knob [◄] [►] to step up or down the FM frequency by
100KHz, and choose a frequency, the screen will show 《 Frequency 》
where Frequency is the chosen frequency.
3. Press the + or – buttons to select a preset memory FX where X is from 1
to 4, and then press and hold the + or – button to save the selected
frequency to memory and it will show 《 FX SAVED 》.