Operation Manual

DAB2000 will tune to the station you selected if the rotary knob is not
pressed. The screen will show 《 TUNING 》. Once tuning is complete, the
screen will show 《 station name 》 where station name is the new DAB
station name selected.
Note:
When the DAB station you have selected is not available, the screen
will show 《 UNAVAIL 》. There will be no audio output from the
DAB2000.
When the signal strength of the DAB station you have selected is too
weak, the screen will show 《 POOR SIG 》.
Each time you start the DAB2000, if the channel list is empty, it will
perform a full scan for available DAB stations automatically.
To display the DAB station’s information
The DAB2000 provides certain information about the current DAB station you
are listening to. This information can be displayed repeatedly by pressing the
Rotary Knob button.
1. Each time you press the Rotary Knob whilst listening to a DAB station,
the screen will cycle through the DAB station’s information below:
《 station name 》where station name is the name of the DAB station.
《 SIG xx% 》 where ‘xx’ is the signal quality.
To set a DAB preset mode
The DAB2000 provides individual memory settings for up to three sets of DAB
preset modes: DAB1, DAB2, and DAB3. Each DAB preset mode has its own
memory presets of DAB stations; please refer to To save a DAB memory
preset and To recall a DAB memory preset sections later in this user guide
for further information. This allows a user to set up to three DAB presets for
different users (driver or passengers) or a different group of DAB stations to
enjoy based on the individual settings.
1. Press the MODE button to select a particular DAB preset mode.
2. Press the Rotary Knob to confirm your selection. After 3 seconds, the
system will tune to the selected preset mode. The screen will then show
《 DONE 》.