Operation Manual

Securing the DAB2000 module, Step by Step
To secure the DAB2000 module in your chosen location using the supplied hook &
loop tape and/or screws, please do the following:
1. Locate the positions on the back of DAB2000 module and your chosen store
location (e.g. in the centre front of the vehicle or behind the vehicle’s glove
compartment) where you want to apply the hook and loop tapes.
2. Clean both the surfaces on the DAB2000 module and your chosen l ocation,
with alcohol if available and wipe dry before you start.
3. Remove one side of the backing from the two pieces of hook and loop tape and
adhere them onto the back of DAB2000 on the marked positions as per the
diagram above.
4. Remove the other side of the backing and adhere the DAB2000 module to the
chosen location with the DAB2000’s cables and connectors to the back.
5. Carefully, separate the two pieces of the hook and loop tape so that the
DAB2000 module and the location each has a piece of the tape.
6. Apply the pressure evenly to all four pieces on the DAB2000 module and the
location, so that the tapes adhere to both surfaces securely.
7. Wait eight hours for the adhesive to cure and bond to the surfaces, and then
join the pieces together.
8. Alternatively, or in addition, you can secure the DAB2000 module in place with
the screws supplied.