Use and Care Manual

EN - 19
3. Loosen jam nut on traction cable
adjustment barrel, and then turn
adjustment barrel down to shorten cable
and remove cable slack.
4. With traction clutch disengaged, check
that swing gate tab touches the front edge
of stop hole. See Figure 29.
IMPORTANT: Swing gate tab MUST touch
side of stop hole. Readjust cable as
necessary until tab touches stop hole.
5. Reconnect spark plug wire.
Figure 28
3
2
1
1. Traction Drive Clutch Cable
2. Cable Adjustment Barrel
3. Jam Nut
Figure 29
1. Swing Gate Tab
2. Stop Hole
1
2