Use and Care Manual

EN - 10
TRACTION DRIVE CLUTCH
LEVER (LEFT SIDE)
See Figure 9.
Allows unit to travel forward and in reverse.
DUAL HANDLE INTERLOCK
Allows auger / impeller to rotate without
holding attachment clutch lever continuously.
Auger continues to turn until both clutch
levers are released.
DISCHARGE CHUTE ROTATION
LEVER
See Figure 10.
Rotates discharge chute left or right to control
snow discharge.
DISCHARGE CHUTE DEFLECTOR
LEVER
See Figure 11.
Moves discharge deflector up or down to
control height of snow discharge.
SCRAPER BLADE
Contacts the surface being cleared and
protects the housing from damage during
normal use.
SKID SHOE
Controls the distance between the scraper
blade and the surface.
AXLE LOCK PIN
Locks or unlocks wheels for better traction
and easier turning.
IMPORTANT: All references to left, right, front
or rear are given from the perspective of
operator in operator’s position, facing the
direction of forward travel.
EMERGENCY STOPPING
1. Release both clutch levers.
2. Set engine switch to stop position and
remove engine key from unit.
3. Wait for all moving parts to stop before
leaving operator’s position.
BEFORE OPERATING UNIT
1. Check for a frozen impeller.
a. Remove key and set engine switch to
stop position.
b. Engage attachment clutch lever and
pull recoil starter handle.
c. If handle does not pull, move unit to a
warm area to thaw.
Figure 9
Figure 10
205°
OPERATION
WARNING: AVOID INJURY.
Read and understand the Safety
section before proceeding.
Figure 11