MSDS
PAGE 2
Inhalation: Remove the person to fresh air, obtain medical attention, and perform articial respiration if needed.
Eye: Flush the eye with water for at least 15 minutes. If irritation persists, seek medical attention.
Skin: Wash exposed skin with mild soap and water. Treat affected area with skin moisturizer.
Ingestion: If large amounts are ingested, do not induce vomiting. Have the victim drink two glasses of water.
Seek medical attention.
Flashpoint: >200
o
F (93.3
o
C)
Explosive Limits: Not Combustible
Autoignition Temperature: None
Unusual Fire and Explosion Habits: None
Hazardous Combustion Products: Upon decomposition, this product emits carbon minoxide, carbon dioxide,
and/or low molecular weight hydrocarbons.
Special Fire Fighting Procedures: Full protective clothing including self-contained breathing apparatus.
Extinguishing Media: Dry Chemical, foam, carbon dioxide, water fog.
Emergency Action: Wear appropriate personal protective equipment. Do not allow product to enter sewer or waterways. Follow
all State, Local, Federal and Provincial regulations for disposal. Regulations vary. Consult local authorities before disposal.
Spill or Leak Procedure: Scrape material up and place in covered container appropriate for disposal. Thoroughly clean area
where spill occurred. remove sources of ignition. Ventilate area of spill.
Containment Procedures: Stop source leak if possible. Contain the discharged material.
Reporting: See Federal reporting requirements listed in Section 15. We recommend you contact local authorities to determine if
there may be other local reporting requirements.
Handling: Do not get this material in your eyes, on your skin, or on your clothing. Avoid breathing vaporsor
mists of this product. Wash hands after handling and before eating.
Storage: Keep in a dry, cool and well-ventilated place. Keep away from heat. Keep away from direct sunlight.
Do not handle or store near an open ame, heat or other sources of ignition.
Empty container Attention! Follow label warnings even after container is emptied since empty containers may retain
precaution: product residues. Do not reuse empty container without professional cleaning for food,clothing, or
products for human or animal consumption, or where skin contact can occur.
Urethane Flexible Grout, as delivered, is an encapsulated product in which the sand component (crystalline silica) is bound in
a polymer matrix. The sand contained in this product cannot be inhaled under conditions of intended product use.
Ventilation: Use general dilution or local exhaust as required to maintain exposures below the occupational
exposure limits; see also ACGIH, Industrial Ventilation – Recommended Practice (latest edition).
Respiratory Protection: Avoid breathing vapors produced during the use and handling of this product. Consult with OSHA
regulations and NIOSH recommendations to determine the appropriate NIOSH-approved respiratory
protection to wear during and following use, including clean-up, of this product.
Gloves: PVC gloves are recommended in situations where skin contact may occur.
Eye: Use ANSI approved protection as appropriate for the task at hand, including goggles or
safety glasses with side shields.
Other: Use protective clothing as appropriate for the work environment.
SnapSys Urethane Flexible Grout Material Safety Data Sheet, Version 1, 11/2013
Floating Porcelain Tile System
MATERIAL SAFETY DATA SHEET
URETHANE FLEXIBLE GROUT