SDS

Floating Porcelain Tile System
MATERIAL SAFETY DATA SHEET
SnapSys Thermoplastic Elastomer/Rubber Material Safety Data Sheet, Version 1.3, 11/2013
PAGE 1
Section 1 – Product identification
Trade Name: GLS 358-052
Article Number: 77189
Common Names: Thermoplastic Elastomer. Application of the substance/preparation rubber
Manufacturer: Poly One/GLS Corporation 833 Ridgeview Drive, McHenry, IL 60050 USA
Telephone: Toll Free: 800-457-8777/ Phone [phone]/ Fax: [phone]
Section 2 – information on HaZardouS ingredientS
The following information provided on the below hazardous pigment(s) and additive(s) applies to them in the pure dry form.
The form of the pigment and additive provided to you is encapsulated in plastic, and therefore the likelihood of the exposure is
much less, even to the point of negligible. We therefore consider the level of hazard to be negligible.
CAS Number Description OSHA PEL (mg/m3) ACGIH TLV (mg/m3) Other Limits Does Not Exceed(%)
68187-51-9 Pigment Yellow 119 N/A N/A N/A 1.29
ZNCMPD Zinc Compound N/A 5.0 N/A N/A
1333-86-4 Carbon Black 3.5 3.5 N/A 4.58
13463-67-7 Titanium Dioxide (dust) 10.0 10.0 N/A 42.58
1344-28-1 Aluminum Oxide (dust) 10.0 10.0 5.0 .43
Section 3 – PHYSicaL / cHemicaL cHaracteriSticS
Boiling Point: N/A
Specic Gravity: 0.84 - 0.97
Vapor Pressure: N/A
Melting Point: 225-275 F (about 140 C)
Vapor Density: N/A
Evaporation Rate: N/A
Solubility in Water: Insoluble
Appearance/Odor: Plastic Pellet - No Signicant Odor
Section 4 – fire and exPLoSion HaZard data
Flash Point (method used): There is a component in this product with a Flash Point of 342 C. The method used to determine
this is: ASTM E136. All other components used in this product either have a higher ash point or
are not combustible and do not have a ash point.
Extinguishing Material: Water Spray, Foam, Carbon Dioxide, or Dry Chemical.
Fire Fighting Procedures: Evacuate area of all unnecessary personnel. Wear appropriate re safety equipment including
self-contained breathing apparatus and protective garments. Use water to cool exposed equipment
and containers.
Fire/Explosion Hazards: It may not be obvious that carbon black is burning unless the material is stirred and sparks are
apparent. Carbon black that has been on re should be observed closely for at least 48 hours to
ensure no smoldering material is present.
THERMOPLASTIC ELASTOMER/RUBBER FOR POLYSTYRENE PLASTIC TRAY