Instructions / Assembly

INSTALLING AND REPLACING ENTRY KEYPAD BATTERY
For all Customer Service questions call toll free: 1-877-214-4470
Visit us at www.snapsafe.com
Install only a high-quality alkaline battery in the compartment in the back of
the Entry Keypad following the steps below.
1. Remove Entry Keypad. Slide it up and carefully pull it away from the vault
door. (Fig.1) Note: Do not pull on the Keypad with too much force as to
damage the cable.
2. Snap new battery into the connector clip, and slide it into the battery
compartment top down so that the wires will not be pinched between the
battery and the vault door. (Fig.2)
3. Fold the connection cable inside the keypad. (Fig.3)
4. Position the keypad over the mounting screws, and slide it down into
position. Note: Make sure the connection cable is not trapped between the
keypad and the door, or rubs or tangles on the mounting screws. (Fig.4)
SnapSafe
®
is a Hornady
®
Company.
REV 07-2016