Users Manual

- 3 -
OFF/
Brightness Settings
Standalone
Connect Settings
1 minute
Time Settings
Duration of time
LEDs remain on
after motion is no
longer detected
Allows user to select
brightness of the LEDs
unit works as a stand
alone motion nightlight
and doesn’t connect to
other units
unit connects with
all units set to
zone 1
unit connects with
all units set to
zone 2
Controls which
other ConnectLights
the unit connects
with
Zone 1
Zone 2
15 seconds
5 minutes
Customization/Setup
STEP 7: Now that your ConnectLight is installed, use the
switches on the unit to customize the brightness of the LEDs,
the length of time the unit stays on, and which zone the unit
connects to.
Motion/Light
Sensor
To connect two or more ConnectLights to each other, simply set each unit
to the same zone using the switch on the left. All the units set to Zone 1
will connect to each other, and all the units set to Zone 2 will connect to
each other. When the units are set to the same zone, motion detected by
one unit will activate the other units on that zone.
To make a pathway in your home, install multiple ConnectLights along
the desired path and set them to the same zone. When one
ConnectLight detects motion, it will activate the other ConnectLights set
to that zone and the entire pathway will light up.
For the latest instructions and trouble shooting
information scan this QR code or go to
https://www.snappower.com/pages/cl-instructions.com
Sleep Mode
LO HI