Section 2 - SAFETY MESSAGES AND SYMBOLS CHOKE "ON" CHOKE "FAST" RABBIT I ] CHOKE "OFF" ENGINE SPEED TURTLE "SLOW" 7 I I
Section 2 - SAFETY MESSAGES AND SYMBOLS I BLAOBSENGAGBO"ON" I BLAOBS DISENGAGED "OFF" I "START" MOTION CONTROL MULTI-DIRECTIONAL I DANGER! ROTATING BLADES KEEP CHILDREN AND OTHERS OUT OF MOWING I DANGER! ROTATING 8 BLADES AREA BEFORE OPERATING READ OPERATOR'S MACHINE MANUAL I
Section 5 - ADJUSTMENTS DANGER & REPAIR _1 5.2 Exercise EXTREME CAUTION when making this I adjustment, due to close proximity of moving parts, I 5.1 NEUTRAL POSITION ADJUSTMENTS The joystick controls the movement and stopping of the machine. Move the joystick to the center or neutral position to stop machine. IMPORTANT: Always return the joystick with hand assistance to the neutral position.
Section 5 - ADJUSTMENTS 5.8 & REPAIR MOWER SPINDLES (Field Serviceable Spindles) BEARING REPLACEMENT 5. Thoroughly clean all parts removing all otd contaminated grease. 6. Install new bottom bearing first. NOTE: The bearing is sealedlshielded on one side only. The bottom bearing must be installed with the sealedtshielded side DOWN. 7. Insert spindle shaft up through the bottom bearing. Slide spacer down over spindle shaft. 8. Install new top bearing. Install the top bearing with the seal/shield UP. 9.
Safety Instructions & Operator's Manual for MID MOUNT Z-RIDER ZERO TURNING HYDRO DRIVE SERIES 0 IMPORTANT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings. Read, Understand, and Follow all warnings and instructions in this manual, the engine manual, and on the machine, engine and attachments.
