Manual

MAINTENANCE INSTRUCTIONS

Usingdistilledwater, fill cells as needed to 1/8" to 3/8"

above cell plates.

Replace cell covers.

Charge battery if required.

Install positive(+) cable first.

Install negative(-) cable last.

Install seat assembly over battery and secure in position

with adjusting knobs. Leave knobs loose.

Lower operator's seat and adjust to desired position.

Raise seat and tighten adjusting knobs.

BATTERY CHARGING

The engine is equipped with a flywheel alternator to

charge the battery. If the tractor is not run regularly,

connectthe batteryto a charger monthlyto maintainthe

specific gravity at 1.250 or higher. If this reading falls

below1.175, the batteryliquidmayfreeze whentempera-

turesdropto aroundzero degrees F. To charge, connect

perinstructionsfumishedwithcharger,If time allows, slow

charge at 1 amp for ten hours, or as an alternate, fast

chargeat 3 amps forfourhours. Observe allprecautions

whilecharging.

.LEY

TRACTION DR!VE-BELT

Check thetractiondrivebeltfordamage andwear after25

operatinghours.The tractiondrive belt is locatedon the

undersideofthetractorandspansfromtheenginepulley's

top grooveto the transmissionpulley. See Figure35.

TRACTION --

DRIVE BELT

FIGURE 35