Manual

TROUBLESHOOTING
BLADE(S) NOT
CUllING
CUTTING GRASS 1.
IMPROPERLY
2.
3.
4.
5.
6.
7,
8.
POOR GRASS 1.
DISCHARGE
1.Bladeengagement leverin the "OFF" position.
2, Blade belt requiresadjustment.
3. Blade belt requiresreplacement.
Uneven tire pressure.
Cuing height too low or high.
Engine speed too slow.
Forward speed too fast.
Deck side to side level requires adjustment.
Deck front to rear level requires adjustment.
Blade belt requires adjustment.
Blade belt requires replacement.
Engine speed too slow.
2. Forward speed too fast.
3. Grass is wet.
4 Excessively worn or damaged blade(s).
5. Build-up of grass clippings and debns under deck.
6. Improper blade(s) installed on deck.
7. Blade(s) installed improperly on deck.
BATTERY WILL NOT 1. Poor cable connections.
CHARGE
2. Bad battery cell(s).
OIL LEAKING
FROM TRANSMISSION
1. Move leverto the "ON"position.
2. Adjust mower belt.
3. Replace mowerbelt.
1. Bringto properpressure.
2. Adjust cuttingheight.
3. Move engine speed oontrol to "FAST'.
4. Move speed controlto a slowerspeed.
5. Adjust sideto sidelevel.
6. Adjustfront to rear level.
7. Adjustblade belt tension.
8, Replace bladebelt.
1. Move engine speedoontrol to "FAST".
2 Move speed control to a slower speed.
3. Mow when grassis dry.
4.Servicemower blade(s).
5.Cleandeck.
6.InstallproperSNAPPER blades.
7.Installbladesproperly,
I.Cean cablesand batteryterminals.
2. Replace withnew battery.
3. Faulty alternator. 3. Contact engine manufacturer's dealer.
1. Loose or missing oil filler cap. (Hydro Models Only) 1. Check oil level and replace oil cap.
2. Leaking axle seals. 2. Contact authorized SNAPPER dealer.
3. Leaking at casing seal 3. Contact authorized SNAPPER dealer.
13