Manual

e-
e-
e"
,E
o=
Howto Replace the Primary Mower Drive Belt
(46 & 52" Models)
1. Remove the mower deck. Seethe instructions on "How
To RemoveThe Mower Deck".
2. Remove the three screws from the left pulley cover.
Removethe pulley cover (Figure 43).
3. To remove the primary mower drive belt from the left
mandrel pulley, slide the primarymower drivebelt
betweenthe left mandrelpulley and the belt guides,
4. Pull the belt retainer awayfrom the idler pulley.
Removethe primarymower drive belt from the idler
pulley.
5. Remove the primarymower drive belt from the stack
pulley.
NOTE:Replacethe primary mower drive belt with an
original equipment belt from an authorizedservice
center.
6. Install a new primary mowerdrive belt. Put the belt
around the stackpulley. Makesure the primary mower
drivebelt is insideof the belt guide.
7. Pull the belt retainer awayfrom the idler pulley. Put
the flat side of the primary mowerdrive belt around
the idler pulley.
8. Make sure the "V" side of the primarymower drive
belt isagainstthe mandrelpulleys as shown.
9. Make sure the primarymower drivebelt is insideall
the belt guides.
10. Assemble the left pulley cover.
11. Install the mower deck. Seethe instructions on "How
To Install The Mower Deck".
12. Before you mow, check the PTOclutch. Seethe
instructions on "How To Adjust The PTOclutch".
Howto Replace the Secondary Mower DriveBelt
(46 & 52" Models)
1. Remove the mower deck. Seethe instructions on "How
To Remove The Mower Deck".
2. Remove the primary mower drive belt from the slack
pulley (Figure 43).
3. Remove the two screws from the right pulley cover.
Remove the pulley cover.
4. Pull the idler pulley away from the secondary mower
drive belt. Removethe belt from the idler pulley.
5. Remove the secondary mower drive belt from the right
mandrel pulley.
6. Remove the secondarymower drive belt from the
stackpulley.
NOTE:Replacethe secondary mower drive belt with an
original equipment belt from an authorizedservice
center.
7. Install a new secondarymower drivebelt. Put the belt
around the bottom of the stackpulley. Make sure the
secondarymower drivebelt is insidethe belt guide
next to the stackpulley.
8. Put the secondarymower drivebelt around the right
mandrel pulley.
9. Pull the idler pulley toward the front. Installthe flat
side of the secondarymowerdrive belt against the
idler pulley.
10. Make sure the "V" side of the secondarymowerdrive
belt is around the right mandrel pulley.
11. Assemble the right pulleycover.
12. Put the primary mowerdrive belt around the stack
pulley.
13. Install the mower deck. Seethe instructions on "How
To Install The Mower Deck".
14. Before you mow, check the PTOclutch. Seethe
instructions on "How To Adjust The PTOclutch".
36
English
www.snapper.com