Manual

Howto Checkand Adjustthe Motion Drive Belt
If the motion drive belt is loose, the belt will slip when; (1)
going up a hill, (2) pulling a heavyload, or (3) the unit will
not move forward. Adjust the belt asfollows.
,_ WARNING:Beforeyou make an inspection,
adjustment,or repair to the unit, disconnectthe
wire tothe sparkplug. Removethe wire from the
sparkplug to preventthe engine fromstarting by
accident.
1. Checkthe routing of the motion drive belt. Makesure
the belt is installed correctly and is inside all the belt
guides.
2. Disconnect the clutchlinkfrom the idler arm (Figure
27).
3. Align the hole in the brake lever with the hole in the
frame. Hold the brake lever in place with a 1/4 inch (6
mm} pinor bolt (Figure 28).
4. Rotatethe clutchlink until the mounting hole in the
clutchlink is aligned with the hole in the idler arm as
shown in Figure 27.
5. Connect the clutchlink to the idler arm
(Figure 27).
6. Removethe 1/4 inch (6 mm) pin or bolt
(Figure 28).
Figure 27: Aligning clutch link
A - Mounting holes
B - Idler arm
C - Clutch link
D - Clutch rod
.
If the belt still slips after the belt has beenadjusted,
then the motion drive belt is worn or damagedand
must be replaced.See "Replacing The Motion
Drive Belt".
¢'D
Figure 28: Adjusting motion drive belt
A - 1/4"(6mm) Pin or bolt
B - Clutch link
C - Idler arm
D - Idler spring
English
E - Motion drive belt
F - Belt guide
G- Brakelever
25