Manualshelf

Install Drawing

ManualsBrandsSnapper ManualsRear Engine Rider2812524BVE (28") 12.5HP Hi-Vac Rear Engine Riding Mower
12345678
BATTERY CHARGING and INSTALLATION
This unit is equipped with a valve-regulated (sealed) non-spillable
battery. It is maintenance-free and requires no service. However,
it does require charging before being placed into service.
1. BATTERY REMOVAL
A. Remove the battery cover (A, Figure 16) by pulling each
side away from the ratchet fasteners (B).
B. Remove the hardware (A, Figure 17) securing the battery
hold-down bracket (B), and remove the bracket.
C. Remove the battery from the battery compartment.
B
A
C
Figure 16
WARNING
The battery on this unit requires the use of a contant voltage (CV)
battery charger designed for valve regulated (sealed) non-spillable
batteries. Attempting to use a standard battery charger may result in
damage to the battery. DO NOT use “BOOST” chargers on the bat-
tery. DO NOT attempt to charge battery while installed on the unit.
! !
5
B
A
Figure 17
3. BATTERY CHARGING
A. Place the battery in a well-ventilated area.
B. Connect a 12-volt constant-voltage battery charger to the
battery terminals; RED to positive (+) and BLACK to nega-
tive (-) terminal.
C. Charge the battery for 2 to 4 hours..
4.
BATTERY INSTALLATION
A. Re-install the battery into the battery compartment, with
the terminals facing outward.
C. Install the positive (+) cable (A, Figure 18) first., secur-
ing with the 1/4” center lock nuts. Place the positive (+)
terminal insulator (B) over positive terminal and cable.
Install negative (-) cable (C) last, after the positive terminal
insulator has been installed.
D. Reinstall the battery hold-down bracket.
E. Reinstall the battery cover. NOTE: The negative cable will
need to be routed over the side of the battery cover.
WARNING
The battery on this unit requires the use of a contant voltage (CV)
battery charger designed for valve regulated (sealed) non-spillable
batteries. Attempting to use a standard battery charger may result in
damage to the battery. DO NOT use “BOOST” chargers on the bat-
tery. DO NOT attempt to charge battery while installed on the unit.
! !
B
A
C
Figure 18
Not for
Reproduction