Install Drawing

3. Seat Installation
A. Position the seat (A, Figure 14) onto the seat
pedestal (B).
B. Install two 5/16 center lock flange nuts (C) onto the rear
seat bolts. Tighten the nuts securely, then loosen 1 to
1-1/2 turns to allow the seat to slide freely.
C. Install the two seat knob spacers (D) onto the front seat
bolts, followed by the two seat knobs (E).
D. Adjust the seat to the desired position. Tighten the seat
knobs to secure the seat in position.
E. Connect the switch wiring harness (A, Figure 15) to the
seat switch (B, under seat). Make sure the locking tab
(C) locks into place on the switch.
A
B
D
E
C
Figure 14
A
C
B
Figure 15
4
2. Seat Switch Installation
A. Insert the seat switch (A, Figure 11) into the bottom of
the seat (B).
B. Slide the switch toward the rear of the seat, and pull up
to snap into place (Figure 12).
C. Make sure both tabs (A, Figure 13) are locked to the
outside edge of hole.
B
A
A
Figure 11
Figure 12
Figure 13
Not for
Reproduction