Manual

Operation(Continued)
Starting and Operation
Engine (Electric Start)
.
After the enginestarts, move the engine speed control
to the "FAST" position and allow a brief warm-up until
engine runs smooth.
IMPORTANT:When the ignition key is turned to "START",the
engine will turn over, but will not start unless the
Clutch/Brake pedal is pressed all the way down, and the
Blade Lever is in the "OFF" position. The operator should be
in the seat.
Start the engine as follows:
1. Openthe vent (B, Figure 2) on the fuel filler cap (A) by
turning counterclockwise.
IMPORTANT:Failureto open the vent on the fuel filler cap
can causethe engine to stall.
2. Move the transmission shift lever to the (N) Neutral
position. Referto the section entitled "Wheel Drive".
Figure 5. Engagingthe clutch/brake pedal
IMPORTANT:DO NOTstart the enginewith the transmission
shift lever in a drive position.
WARNING
It is possible to start the engine with the transmission
shift lever in a drive position. Follow starting instructions
carefully.
2. Make certain the BladeLever (A, Figure 4) is in the
"OFF" position.
mo
Figure 6: Enginespeedcontrol
Figure 4: Bladelever (in 'Off' position)
3. Pressthe Clutch/Brake Pedal(A, Figure 5) all the way
down and hold while starting the engine.
5. Move the engine speedcontrol (A, Figure 6) to the
choke position (B) to start a cold engine.
6. Turnthe ignition key (A, Figure 7) to the "START"
position until the engine starts.
NOTE: If after 5 seconds of cranking the engine doesnot
start, releasethe key, make sure the Clutch/BrakePedal is
fully depressed,and attempt starting again after waiting for
approximately 20 seconds.
Figure 7: Ignition key
(Continuedon Next Page)