Manual

,m
Operation
Pre-StartCheckList
Make the following checks and perform the service required
before each start-up:
1. Checkthe tire pressure; add or releaseair as neededto
bring pressureto 12 PSI in front and 12 PSI in rear.
2. Checkguards, deflectors and covers to make sure all are
in place and securely tightened.
3. Checkengineoil and add oil as neededto bring level up
to the FULLmark (A, Figure1). Referto the engine
manual for oil specifications.
OperatorSeatAdjustment
1. With the engine stopped, loosenthe two adjusting
knobs (B, Figure3) and move the seatto the desired
position. After adjustment, tighten the knobs securely.
NOTE:If the seat does not move after loosening the knobs, it
may be necessary to loosen the 5/16" patch lock screws or
hex nuts (C) located at the rear of the seat.
Figure 1: Engine oil 'Full' mark
4. Adjust the seat(A, Figure 3) as neededto the most
comfortable position. Referto the Section entitled
"OPERATOR'SSEATADJUSTMENT".
5. Checkthe blade control to insure it works freely. If the
blade pedals are depressed,the blade levercan be
moved manuallyfrom "ON" to "OFF"to stop the blade.
6. Checkthe Reverse Lockout Mechanism. With the blade
pedals depressed, the shift lever must not go into
reverse.
7. Cleanthe exterior surfaces of the cutting deck and
engine of any accumulation of dirt, grass, oil, etc. Keep
the engine air intake screenand cooling fins clear at all
times.
8. Add fuel to the fuel tank after pushing the RearEngine
Rider outside where fumes can dissipate. Make sure the
fuel filler cap (A, Figure2) is tight, and the vent (B) is
open after refueling. Referto the engine manual for fuel
specifications.
Figure 3: Operator seatadjustment
Figure 2: Fuel filler cap
6 www.snapper.com