Manual

Before connecting garden hose to water inlet, inspect

inlet screen. Cleanscreen (A) if it contains debris or have

it replacedif damaged.DONOTrunpressure washer if

inlet screenisdamagedor missing.

4. Run water through garden hose for 30 seconds to flush

it of debris. Turn off water.

NOTICE DO NOTsiphon standing water for the water

supply. UseONLYcold water (less than 100°F).

5. Connect garden hose (not to exceed50 feet in length) to

water inlet. Tighten by hand.

NOTICE Using a One Way Valve (vacuum breaker or check

valve) at pump inlet can causepump or inlet connector

damage.

• ThereMUSTbeatleastten feetof unrestrictedgardenhose

betweenthe pressurewasherinletandanydevice,suchasa

vacuumbreakeror checkvalve.

• Damageto equipment resulting from failure to follow this

instruction will void warranty.

_i, WARNING Risk of eye injury.

Spray can splash back or propel objects.

• Always wear indirect vented (chemical splash) safety goggles

marked to comply with ANSI Z87.1 when using or in vicinity of

this equipment.

NEVERsubstitute safety glasses or dry-condition goggles for

indirect vented safety goggles.

Turn ON the water, press red button (B) on the gun and

squeeze the trigger to purge the pump system of air and

impurities.

Checklist Before Starting Engine

Reviewthe unit to ensureyou haveperformed all of the

following:

1. Besure to read SafetyRules and Operationsections

before using the pressure washer.

2. Makesure handleis in place and secure.

3. Checkthat oil has beenadded to proper level in engine

crankcase.

4. Add proper fuel to fuel tank.

5. Checkfor proper hose connections (high pressure and

water supply) and that there are no kinks, cuts, or

damageto the high pressure hose.

6. Provide proper water supply (not to exceed100°F).