Manual

CAUTION!Alcohol-blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an enginewhile in storage.
To avoid engineproblems, the fuel system should be treated
with afuel preserver or emptied beforestorageof 30 daysor
longer. If adding a fuel preserver, fill the fueltank with fresh
fuel. If only partially filled, air in the tank will promote fuel
deterioration during storage. If fuel preserver is not used,
drain the fuel tank, start the engineand let it run until the fuel
lines and carburetorareempty. Usefresh fuel nextseason.See
Storagefor additional information.
NEVERuse engine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
HighAltitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane/ 85 AKI (89 RON)gasoline is acceptable.To
remain emissions compliant, high altitude adjustment is
required. Operation without this adjustment will cause
decreasedperformance, increasedfuel consumption, and
increased emissions. Seea qualified Sears dealerfor high
altitude adjustment information. Operation of the engineat
altitudes below 2,500 feet (762 meters) with the high altitude
kit is not recommended.
FreshStart® FuelCap
The FreshStart® fuel cap(A) is designed to hold a
cartridge (B) which contains fuel preserver. Adding fuel
preserver helps keep fuel fresh and carburetors clean for
easier starting all seasonlong. The FreshStart® fuel cap, if
equipped with a cartridge, automatically drips concentrated
fuel preserver into your fuel tank so you don't haveto add it
_ourself.
Connect Hose and Water Supply to Pump
NOTICE DO NOTrun the pump without the water supply
connected and turned on.
• Damageto equipmentresultingfromfailuretofollowthis
instructionwill voidwarranty.
NOTE:Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
%
_ILWARNINGThe high pressure stream of water that
this equipment produces can cut through skin
and its underlyingtissues, leadingto serious
injuryand possible amputation.
• NEVERconnecthigh pressurehoseto nozzleextension.
• Keephighpressurehoseconnectedto pumpandspraygun
whilesystemis pressurized.
• Alwaysbecertainspraygun,nozzlesandaccessoriesare
correctlyattached.
2. Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
NOTE:FreshStart® fuel preserver cartridge is available as an
optional accessory, retail item 7133386. It is not included
with the pressurewasher. Contact the original equipment
manufacturer, retailer,or dealer to obtain a cartridge
designed for the FreshStart® fuel capinstalled on this
engine.
Read and follow all instructions andwarnings given in the
FreshStart® fuel preservercartridge package.