Manual

Your pressure washer requires some assembly and is ready
for useonly after it has been properly serviced with the
recommended oil and fuel.
If you haveany problems with the assemblyof your
pressurewasher, please call the pressurewasher helpline
at 1-800-317-7833.
UNPACKPRESSUREWASHER
1. Remove everything from carton except pressurewasher.
2. Opencarton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTONCONTENTS
Check all contents. If any parts are missing or damaged,call
the pressure washer helplineat 1-800-317-7833
• Main Unit
• Handle
• Cleaning Tank
• High PressureHose
• Spray Gun
• PrecisionSprayTMSelector
• Spray GunWireform
• DetergentSiphon Hose
• Oil Bottle
• Parts Bag(which includes the following):
• Operator's Manual
• Owner's Registration Card
• HandleFasteningHardwareKit (whichincludes):
• Carriage Bolts (2)
• "L" Bolt
• Plastic Knobs (4)
• Tree Clips (4)
Becomefamiliar with each piece before assembling the
pressure washer Identify all contents with the illustration on
page 6 If any parts are missing or damaged, call the
pressure washer helpline at 1-800-317-7833
ASSEMBLINGPRESSUREWASHER
Your Snapperpressure washer will needassembly before
operation:
1. Fill out and send in registration card.
2. Attach handle and cleaning tank.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect pressure hose to spray gun and pump.
7. Connect water supply to pump.
8 Attach PrecisionSprayTMselector to spray gun
Attach Handle and Cleaning Tank
1. Place handle(A) onto handle supports (B) connected to
main unit. Make sure holes (6) in handlealign with holes
(6) on handlesupports.
NOTE:It may be necessaryto move the handlesupports
from side to side in order to align the handleso it will slide
over the handlesupports.
2. Placecleaning tank over holes on handle and handle
supports (viewing from rear of unit).
3. Insert carriage bolts (D) through top holes of the handle,
handlesupports and cleaning tank from front of unit and
attach a plastic knob (E) from rear of unit. Tighten by
hand.
.
Push tree clips (F) into bottom holes (G) of cleaning
tank (N) and holes on handle supports until they sit flat
against cleaning tank.
V
5. Insert "L" bolt (J) through hole on left side of handle
(viewing from front of unit). Hold bolt in place and attach
a plastic knob (K) from inside of unit. Tighten by hand.