Manual

How to Stop Your Pressure Washer
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOWposition, then STOPposition.
_i, WARNING Backfire,fire or engine damagecould
occur.
• DONOT stop engine by moving choke control to "Choke"
position (J",l).
3. ALWAYS point spray gun in a safe direction, press red
button and squeezespray gun trigger to releaseretained
high water pressure.
IMPORTANT:Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
_i, WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leadingto serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keephighpressurehoseconnectedto pumpandspraygun
whilesystemis pressurized.
• ALWAYSpointspraygunin safedirection,pressredbutton
andsqueezesprayguntriggerto releasehighpressure,every
timeyou stopengine.
How to Use PrecisionSprayTM Selector
Refer to the PrecisionSprayTM Selector instruction sheetfor
proper use.
NOTICE Product damagewill occur if the gun trigger is
squeezedwhile the Selector is in-between nozzlesettings.
• NEVERturn theSelectorwhilespraying.
Cleaning and Applying Detergent
_i, CAUTION Chemicals can cause bodily injury, and/or
property damage.
• NEVERusecaustic liquid with pressure washer.
• Use ONLYpressure washer safe detergents/soaps. Follow all
manufacturers instructions.
Toapplydetergentfollowthesesteps:
1. Attach one of the detergent siphon hoses following
instructionsAttach DetergentSiphon Hose to Pump.
NOTICE Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
2. Preparedetergent solution as required by job.
3. Make sure detergent shut-off valve on cleaning tank is in
"Off" position.
4. If using cleaning tank, pour detergent into cleaning tank.
NOTE:The cleaning tank holds two gallons.
NOTICE Cleaningtank damage may occur if not drained
prior to removing handle.
5. Rotate PrecisionSprayTM Selector to a low pressure
position, asdescribed in the PrecisionSprayTM Selector
instuction sheet.
NOTE:Detergent cannot be applied with the PrecisionSprayTM
Selector in a high pressure position.
6. Make sure garden hose is connectedto water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ONwill damagethe pump.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
7. Start enginefollowing instructions How to Start Your
Pressure Washer.
13