Operator's Manual
Table Of Contents
Not for
Reproduction
20
34
3. Check the fill/level plug (A, Figure35) on the chain case
(B) for damage. If signs of wear or cracks are visible,
replace with a new plug.
4. To check lubricant in the chain case, remove the fill/level
plug and look for lubricant on the internal components of
the chain case. If no lubricant is visible, add transmission
grease as needed.
35
Engine Maintenance
Change the Engine Oil
1. Run the engine until warm.
2. Place the rider on a level surface.
3. Stop the engine and remove thekey.
4. Clean the oil fill and filter areas of any debris.
5. Remove the dipstickand lay on a clean cloth.
6. Disconnect the oil drain hose (A, Figure36).
36
7. Carefully remove the cap (B, Figure36) and lower the
hose into an approved container (C).
8. After the oil has drained, install the cap tightly, then attach
the hose to the side of the engine.
9. Remove the oil filter (B, Figure37) and dispose of
properly.