Operator's Manual

Not for
Reproduction
11
6. After the engine starts, move the engine speed control
to FAST and allow a brief warm-up until the engine runs
smooth.
Manual Start
Start the engine as follows:
1. Move the transmission shift lever to (N) Neutral.
SeeWheel Drive.
WARNING
It is possible to start the engine with the transmission shift
lever in a drive position.DO NOT start the engine with the
transmission shift lever in a drive position.
2. Make sure that the Blade Lever (A, Figure8) is OFF.
3. Press the Clutch/Brake Pedal (A, Figure12) all the way
down, move the park brake latch (B) over, and release
the clutch/brake pedal to set the park brake.
12
4. Move the engine speed control (A, Figure10) to CHOKE
(B) to start a cold engine.
5. Turn the ignition key (A, Figure13) to ON.
13
6. Pull the start rope, located on the engine recoil, with a
smooth, even motion until the engine starts.
Note:Always guide the starter rope back into the recoil
housing. Never allow rope to snap back.
After the engine starts, move the engine speed control to
FAST.
7. Allow a brief warm-up until the engine runs smooth.
In the event of an emergency the engine can be stopped by
turning the ignition key to OFF. For normal engine shut down,
follow the procedure given inStop the Rider and Engine.
Stop the Rider and Engine
WARNING
Fuel and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
• Do not choke the carburetor to stop the engine.
WARNING
DO NOT leave the machine with the engine running. STOP
Blade. STOP engine. Shift to neutral and engage park
brake. Remove key.
Engine
1. Stop the engine by turning the key (A, Figure14) to
OFF.