Product Manual

Not for
Reproduction
Note: The Tire Inflation Pressure can be slightly different from
the "Maximum Inflation" shown on the side of the tires.
Clean the Battery and Cables
WARNING
When removing or installing battery cables, disconnect the
negative cable FIRST and reconnect it LAST. If not done in
this order, the positive terminal can be shorted to the frame
by a tool.
10
1. Disconnect the cables from the battery, negative (-) cable
first.
2. Remove the battery hold-down strap and battery.
3. Clean the battery compartment with a solution of baking
soda and water.
4. Clean the battery terminals and cable ends with a wire brush
and battery terminal cleaner until shiny.
5. Reinstall the battery in the battery compartment, and secure
with the battery hold-down strap.
6. Reattach the battery cables, positive (+) cable first (A, B,
Figure 10).
7. Coat the cable ends and battery terminals with petroleum
jelly or non-conducting grease.
Charge the Battery
WARNING
Keep open flames and sparks away from the battery; the
gasses coming from it are highly explosive. Ventilate the
battery well during charging.
A dead battery or one too weak to start the engine may be the
result of a defect in the charging system or other electrical
component. If there is any doubt about the cause of the problem,
see your dealer. If you need to replace the battery, follow the
steps under Clean the Battery and Cables .
To charge the battery, follow the instructions provided by the
battery charger manufacturer as well as all warnings included
in the safety rules sections of this book. Charge the battery until
fully charged. Do not charge at a rate higher than 10 amps.
Check Mower Blade Stop Time
WARNING
If the mower blade does not come to a complete stop within
5 seconds, the clutch must be adjusted. Do not operate the
machine until the proper adjustment has been performed by
an authorized dealer.
Mower blades and mower drive belt should come to a complete
stop within five seconds after electric Power Take-Off (PTO)
switch is turned OFF. If mower drive belt does not stop within
five seconds, see an authorized dealer for repairs.
Change the Engine Oil
1. Run engine until warm.
2. Place the rider on a level surface (refer to Figure 11).
13