Use And Care Manual
12
OPERATION
Figure 7
Hight/Low speed button
On/Off button
Switch trigger
Lock-out button
ADJUSTING THE ANGLE OF POLE SAW HEAD
See gure 8
1. Pull the angle adjustment handle (1) down. The angle adjustment lock shaft (2) will down at the same time.
2. Rotate the power output head (3) clockwise to adjust the cutting angle.
3. The angle can be adjusted between 0 and 90 degrees.
4. When the angle is well adjusted, release the angle adjustment handle (1).
5. The angle adjustment lock shaft directly insert into the angle adjustment positioning hole (4).
PREPARATION FOR CUTTING
• Wear non-slip gloves for maximum grip and protection.
• Maintain a proper grip on the unit whenever the motor is running. Use your right hand to rmly grip the rear handle while
your left hand has a rm grip on the pole shaft.
• Hold unit rmly with both hands. Always keep your left hand on the pole shaft and your right hand on the rear handle, so
your body is to the left of the chain line. Never use a left-handed (cross- handed) grip, or any stance that places your body
or arm across the chain line.
• Never stand directly under the limb you are cutting.
• Be certain the collars are fully tightened before operating equipment; check them periodically for tightness during use to
avoid serious injury.
BASIC CUTTING PROCEDURE
See gure 9
Follow the steps below to prevent damage to tree or shrub bark. Do not use a back-and-forth sawing motion.
• Make a shallow rst cut (1/4 of limb diameter) on the underside of the limb close to the main limb or trunk.
• Make a second cut from the top side of the limb outboard from the rst cut. Continue the cut through the limb until the
limb separates from the tree. Be prepared to balance the weight of the tool when the limb falls.
• Make a nal cut close to trunk.
1
2
3
4
Figure 8.1
Figure 8.2
Figure 8.3
Not for Reproduction