Manual
CAUTION
. Always wear eye protection when installing/removing e-rings.
6. Repeat step 3 through 5 to secure second wheel.
7. Attach vibration mounts to support leg with I/4-20 x I"
capscrews and I/4-20 lock nuts.
8. Tip generator so that engine side is down.
9. Remove existing hardware from left unit vibration
mount with 13mm wrench. Use same hardware to
attach support leg.
I 0. Attach other side of support leg with a P18 x 20 mm
capscrew and P18 lock nut.
I. On support leg end of generator, slide handle onto
center of top of frame.
2. Attach handle using two long (P18 x 45mm) cap screws
and two locking hex nuts.Tighten with a I/2" or 13mm
socket and wrench.
3. Return generator to normal operating position (resting
on wheels and support leg).
14. Check that tires are inflated to value marked on tire
or within IS and 40 psi.
BEFORE STARTING THE
ENGINE
Add Engine Oil
• Place generator on a level surface.
• Refer to engine operator's manual and follow oil
recommendations and instructions.
CAUTION
. Refer to engine operator's manual for oil fill information.
. Damage to equipment resulting from failure to follow this
instruction will void warranty.
1
NOTE: Check oil often during engine break-in. Refer to
engine operator's manual for recommendations.
NOTE: The generator assembly rotates on a prelubricated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.
Add Fuel
NOTE: This gasoline engine is certified to operate on
gasoline. Exhaust Emission Control System: EP1 (Engine
Modifications).
WARNING
WHEN ADDING FUEL
. Turn generator OFF and let it cool at least 2 minutes before
removing fuel cap.Loosen cap slowly to relieve pressure in
tank.
. Fillfuel tank outdoors.
. DO NOT overfill tank.Allow space for fuel expansion.
. Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
. DO NOT light a cigarette or smoke.
Use clean, fresh, regular UNLEADED fuel with a
minimum of 85 octane. DO NOT use fuel which
contains Methanol. DO NOT mix oil with fuel.
2. Clean area around fuel fill cap, remove cap.
3. Slowly add regular unleaded fuel to fuel tank. Be careful
not to overfill.Allow about 1.5" of tank space for fuel
expansion (Figure 2).
_ _ rTank
4. Install fuel cap and wipe up any spilled fuel.