Manual

SNAPPER "°
WARNING
, ALWAYS point gun in safe direction and squeeze spray gun
trigger, to release pressure and avoid kickbacl< each time,
before starting engine. Engage trigger loci< when not in use.
, When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
, After each starting attempt, where engine fails to run, always
point gun in safe direction and squeeze spray gun trigger to
release high pressure.
, Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when gun kicl<s back.
WARNING
, DO NOT touch hot surfaces and avoid hot exhaust gases.
, Allow equipment to cool before touching.
, Keep at least 5 ft. (152 cm) clearance on all sides of pressure
washer including overhead.
, Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California a
spark attester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
WARNING
, DO NOT wear loose clothing, jewelry or anything that may
be caught in the starter or other rotating parts.
, Tie up long hair and remove jewelry.
WARNING
NEVER aim spray gun at people, animals or plants.
DO NOT allow CHILDREN to operate pressure washer.
NEVER repair high pressure hose. Replace it.
NEVER repair leaking connections with sealant of any kind.
Replace o-ring or seal.
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
ALWAYS point gun in safe direction and squeeze spray gun
trigger, to release high pressure, every time you stop engine.
Engage trigger lock when not in use.
WARNING
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
WARNING
WHEN ADJUSTING OR HAKING REPAIRSTOYOUR
PRESSURE WASHER
" Disconnect spark plug wire from spark plug and place wire
where it cannot contact spark plug.
WHEN TESTING FOR ENGINE SPARK
Use approved spark plug tester.
DO NOT check for spark with spark plug removed.