Manual
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun and nozzle extension.There is also a
hook at the front of the accessory tray to hold your high
pressure hose.
NOTE: The extra hole in the tray is for storing a utility
brush.The extra clip in the tray is for storing a turbo
nozzle.The brush and turbo nozzle are NOT included with
your pressure washer.You can buy these items as optional
accessories.
I. Place nozzle extension through hole on accessory tray,
as shown in Figure 13.
I
2. Place spray gun through hole on accessory tray on
right side of unit (Figure 13).
3. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown in Figure 13.
How to Use SprayTips
The quick-connect on the nozzle extension allows you to
switch between four different spray tips.The spray tips vary
the spray pattern as shown (Figure 14).
CAUTION
. NEVER exchange spray tips without engaging the safety latch
on the spray gun trigger.
Follow these instructions to change spray tips:
I. Engage trigger loci< on spray gun.
2. Pull bad< collar on quick-connect and pull current
spray tip off. Store spray tips in holder provided on the
nozzle extension.
3. Select desired spray tip:
• For gentle rinse, select white 40 ° spray tip.
• To scour surface, select yellow 15° or red 0° spray
tip.
• To apply chemical, select black spray tip.
Low Pressure
Black
Use to apply
chemical
High Pressure
40 ° White 15° Yellow 0 ° Red
4. Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
5. For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too close, you may damage cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
CAUTION
. Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
. Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
I. Review spray tip use.